HP 자격증 HP0-Y35 시험덤프

ITExamDump의 HP 인증 HP0-Y35시험덤프공부자료 출시 당시 저희는 이런 크나큰 인지도를 갖출수 있을지 생각도 못했었습니다. 저희를 믿어주시고 구매해주신 분께 너무나도 감사한 마음에 더욱 열심히 해나가자는 결심을 하였습니다. HP 인증 HP0-Y35덤프자료는ITExamDump의 전문가들이 최선을 다하여 갈고닦은 예술품과도 같습니다.100% 시험에서 패스하도록 저희는 항상 힘쓰고 있습니다.

ITExamDump의 HP인증 HP0-Y35시험덤프는 고객님의 IT자격증을 취득하는 꿈을 실현시켜 드리는 시험패스의 지름길입니다. HP인증 HP0-Y35덤프에는 실제시험문제의 거의 모든 문제를 적중하고 습니다. ITExamDump의 HP인증 HP0-Y35덤프가 있으면 시험패스가 한결 간편해집니다.

ITExamDump의 완벽한 HP인증 HP0-Y35덤프는 고객님이HP인증 HP0-Y35시험을 패스하는 지름길입니다. 시간과 돈을 적게 들이는 반면 효과는 십점만점에 십점입니다. ITExamDump의 HP인증 HP0-Y35덤프를 선택하시면 고객님께서 원하시는 시험점수를 받아 자격증을 쉽게 취득할수 있습니다.

여러분은 아직도HP HP0-Y35인증시험의 난이도에 대하여 고민 중입니까? 아직도HP HP0-Y35시험 때문에 밤잠도 제대로 이루지 못하면서 시험공부를 하고 있습니까? 빨리빨리ITExamDump를 선택하여 주세요. 그럼 빠른 시일내에 많은 공을 들이지 않고 여러분으 꿈을 이룰수 있습니다.

시험 번호/코드: HP0-Y35

시험 이름: HP (Wireless Networks - ASE 2011 Delta Exam)

HP인증 HP0-Y35시험패스는 고객님의 IT업계종사자로서의 전환점이 될수 있습니다.자격증을 취득하여 승진 혹은 연봉협상 방면에서 자신만의 위치를 지키고 더욱 멋진 IT인사로 거듭날수 있도록 고고싱할수 있습니다. ITExamDump의 HP인증 HP0-Y35덤프는 시장에서 가장 최신버전으로서 시험패스를 보장해드립니다.

HP0-Y35 덤프무료샘플다운로드하기: http://www.itexamdump.com/HP0-Y35.html

NO.1 Which protocols/technologies can be used to implement IRF MAD? (Select two.)
A. NSF/GR
B. ICMP
C. IGMP
D. BFD
E. LACP
Answer: D,E

HP   HP0-Y35   HP0-Y35   HP0-Y35 dump   HP0-Y35 dump

NO.2 Which sampling mechanisms are available in sFlow in A-Series switches and routers? (Select
two.)
A. packet-based
B. packet-length-based
C. time-based
D. ip-protocol-based
E. ip-source-address-based
F. mac-address-based
Answer: A,C

HP pdf   HP0-Y35   HP0-Y35기출문제   HP0-Y35

NO.3 Given an HP A5800 switch that is in its factory default configuration, what happens after the
following command sequence? (Note: There is no save command.) system-view irf member 1
renumber 2 quit reboot
A. The IRF member ID will be 1.
B. The IRF member ID will be 2.
C. The IRF member ID will be assigned dynamically.
D. The IRF member ID will be "unknown."
Answer: B

HP자료   HP0-Y35   HP0-Y35   HP0-Y35

NO.4 Using HP A5800 switches, which element must be configured in all switches involved in Layer 2
remote port mirroring?
A. remote-mirroring group
B. mirroring-ingress port
C. monitor-egress port
D. remote-probe VLAN
Answer: D

HP dumps   HP0-Y35 dumps   HP0-Y35인증   HP0-Y35   HP0-Y35인증

NO.5 Click the Exhibit button.
An IRF-stack is being built using HP A5800 switches, and IRF member 1 will be connected to IRF
member 2 using IRF-port 2. Which IRF-port should it be connected to?
A. 1
B. 2
C. 3
D. any
Answer: A

HP   HP0-Y35   HP0-Y35

NO.6 After a MAD enabled IRF-stack splits, what happens to the part of the stack that entered Recovery
state?
A. All ports, except for the IRF-ports, BFD enabled ports, and console ports are shut down.
B. All ports, except for the IRF-ports, LACP enabled Link aggregation groups, console ports, and
manually excluded ports are shut down.
C. All ports, except for the IRF-ports, console ports, and manually excluded ports, are shut down.
D. All ports except for manually excluded ports are shut down.
Answer: C

HP   HP0-Y35   HP0-Y35

NO.7 Which roles are supported by the sFlow standard?
A. agent and collector only
B. probe and collector only
C. agent, collector, and analyzer
D. probe, collector, and analyzer
Answer: A

HP자격증   HP0-Y35 pdf   HP0-Y35인증

NO.8 You have been asked to deploy an additional HP A-Series wireless access point in the conference room
of an advertising agency. You connect to the CLI of the access controller and create an AP management
template. In which view do you specify the serial number of the access point?
A. Radio view
B. Service Template view
C. AP view
D. ESS Interface view
Answer: C

HP   HP0-Y35   HP0-Y35

NO.9 In an IRF stack, which operational plane is centralized (in the Master) and which is distributed
(among all members)?
A. Management: centralized
Control: centralized
Forwarding: centralized
B. Management: distributed
Control: distributed
Forwarding: distributed
C. Management: centralized
Control: distributed
Forwarding: distributed
D. Management: distributed
Control: centralized
Forwarding: distributed
E. Management: centralized
Control: centralized
Forwarding: distributed
Answer: E

HP   HP0-Y35기출문제   HP0-Y35   HP0-Y35   HP0-Y35

NO.10 Click the Exhibit button.
You have recently upgraded the Comware of an HP A-Series Access Controller (AC). Prior to
rebooting the device, you issued the dir command to display the contents of the flash root
directory. Upon reboot, the AC does not successfully run the new version of firmware. What is the issue?
A. The device does not have enough memory to run the new firmware.
B. The filename of the firmware is incorrect.
C. The new firmware is not present in the root directory.
D. Thebootware of the device requires updating as well.
Answer: B

HP   HP0-Y35   HP0-Y35기출문제   HP0-Y35   HP0-Y35 pdf   HP0-Y35

NO.11 Click the Exhibit button.
A network administrator is managing an HP A-Series Wireless Access Controller at the command
line interface (CLI). The administrator issues a command to view the contents of the controller
flash directory. Looking at the output, which access point models can the controller boot and
command to view the contents of the controller? flash directory. Looking at the output, which
access point models can the controller boot and manage? (Select two.)
A. HP WA2220-AG
B. HP WA2612-AGN
C. HP WA2620-AGN
D. HP WA2610E-AGN
E. HP WA2620E-AGN
Answer: B,C

HP   HP0-Y35   HP0-Y35기출문제   HP0-Y35   HP0-Y35 dump

NO.12 What are acceptable topologies for an IRF-Stack? (Select two.)
A. star
B. tree
C. daisy-chain
D. mesh
E. ring
Answer: C,E

HP자격증   HP0-Y35   HP0-Y35 dump   HP0-Y35   HP0-Y35최신덤프

NO.13 You have been asked to deploy a guest wireless service within an A-Series solution in the
reception area of a marketing firm. The clients associated with the guest service should be
assigned to VLAN 10. In which view do you assign the VLAN to the wireless service?
A. System view
B. Service Template view
C. VLAN Interface view
D. ESS Interface view
Answer: D

HP기출문제   HP0-Y35   HP0-Y35

NO.14 Click the Exhibit button.
When IRF with Distributed Link Aggregation is implemented at all layers of a LAN (Core,
Aggregation, and Access), which protocols can be replaced by IRF functions? (Select two.)
A. MSTP
B. LACP
C. BFD
D. NSF/GR
E. VRRP
Answer: A,E

HP   HP0-Y35   HP0-Y35 dump   HP0-Y35   HP0-Y35시험문제   HP0-Y35기출문제

NO.15 Click the Exhibit button.
You have been asked to configure the switching engine of an HP A3000-24G PoE+ Wireless
Switch. First, you log in to the CLI of the access controller and then move to the System view. You
then attempt to issue the partial command oap co and use the Tab key to complete it. However,
the CLI does not complete the command but issues a line return instead, as shown in the exhibit.
What must you do to connect to the CLI of the switching engine?
A. Return to the User view and then issue the command.
B. Enter the OAP view and then issue the command.
C. Use the CTRL+K key combination to access the CLI of the switching engine.
D. Telnet directly to the IPaddress of the switching engine and issue the command.
Answer: A

HP   HP0-Y35   HP0-Y35   HP0-Y35 pdf

HP 인증HP0-Y35인증시험공부자료는ITExamDump에서 제공해드리는HP 인증HP0-Y35덤프가 가장 좋은 선택입니다. ITExamDump에서는 시험문제가 업데이트되면 덤프도 업데이트 진행하도록 최선을 다하여 업데이트서비스를 제공해드려 고객님께서소유하신 덤프가 시장에서 가장 최신버전덤프로 되도록 보장하여 시험을 맞이할수 있게 도와드립니다.